ThermoFlex HTV Metal Flake 15 Foot - ROLL

ThermoFlex Plus Metal Flake is available in 18 colors. These colors cannot have layers adhered on top of them, although we have successfully layered these products on top of other colors.

• Create your design in graphics software.
• Load ThermoFlex Plus onto your plotter.
• Always test cut to ensure proper depth, speed and down force.
• Cut in mirror image.
• Weed film from carrier that you do not want to transfer.
• Place image on the surface to which you are transferring the film
• Place a Teflon sheet between the heat platen and the polyester carrier sheet to prevent sticking and edge damage to the transferred design.
• Heat press between 315 Degrees F 15-20 seconds using firm even pressure.
• If ThermoFlex Plus only partially adheres to the fabric it is usually because insufficient or uneven pressure was applied. If this happens, re position the design, increase the pressure and repress.
• Peel warm or cold. It is much easier to peel while still warm but for consistent results allow at least 10 seconds of cooling time before peeling. For greater durability, cover with a Teflon sheet and repress for 10 seconds.
• Turn garment inside out before washing. Wash in warm to hot water. You can tumble dry ThermoFlex Plus decorated garments on high heat without the transfer film sticking to itself.

ThermoFlex Plus is very durable and if properly applied, will last for the life of the garment.

You can apply ThermoFlex Plus to cotton, polyester, blends, Spandex, Lycra, wool and linen.ThermoFlex Plus will NOT adhere to nylon.